 |
|
|
Yes, One TIME® wood protector is a proprietary acrylate resin blend that
contains no water, wax or solvents. The resins are cured by natural sunlight
and become part of the cellular structure of the
wood. One TIME® contains 100 percent solids, where conventional treatments
usually contain only 5-20 percent solids. Conventional treatments typically
contain water and/or solvents that can cause the wood's cellular structure to
swell, then shrink as it dries, causing cracking. Water and solvents also
dissipate quickly into the air. And because most wood treatments build up on
the surface and eventually wash away, it becomes necessary to reseal the wood
every one-to-two years. |
|
|
|
Because One TIME® penetrates and is cured into the wood, it provides protection
for seven years. As a result, Bond Distributing offers a 7-year warranty on
One TIME®, compared to the one-to-two year warranties offered with conventional
treatments. |
|
|
|
One TIME® can be used on virtually any type of exterior wood or wood product.
When treating NEW CEDAR WOOD AND REDWOOD needs to be naturally weathered for one year before applying One TIME. We highly suggest
using Red Cedar or Clove Brown on any cedar and redwood.
The most common residential applications include decks, fences, log homes,
sheds, shake roofs, wood siding, yard and garden furniture, and children's play
sets. Popular commercial applications include restaurant decks, boardwalks,
boat docks, park benches, bleachers, posts and border treatments. |
|
|
|
Coverage performance depends on the condition of the wood surface being
protected. If the wood is fairly new (less than 5 years old), smooth and has
minimal cracks and crevices, each gallon of One TIME® covers approximately
300-350 square feet. On older and/or slightly damaged wood surfaces, One TIME®
will cover about 250-300 square feet per gallon. Conventional treatments offer
significantly less coverage per gallon. |
|
|
|
Actually, One TIME has been proven to protect
outdoor wood structures for more than eight years. At Bond Distributing’s
field-testing site, one application of One TIME was applied to an outdoor wood
structure, and after eight years there is still no evidence of fungal growth,
warping, cupping, or splitting. |
|
|
|
One TIME® is very easy to apply using any of the standard methods - brush, low
nap roller, paint pad, or an airless paint sprayer. However, it is important to prepare the wood
surface before applying. |
|
|
|
After applying One TIME® clean your equipment with a quality cleaning product such as
Simple Green All-Purpose Cleaner and Degreaser. |
|
|
|
If a new wood surface is being sealed, the wood must be thoroughly cleaned with
a quality cleaner such as Bond Distributing's Two StepTM Wood Cleaner and dried
for 48 hours before applying One TIME®. Any dirt or stains not removed will be
permanently sealed into the wood. |
|
|
If the wood surface has been previously treated with other products, it must
be removed by using a quality stain and sealer remover like One TIME® Stain and Sealer Remover. Otherwise, the existing
treatment may inhibit the penetration of One TIME® and may cause the wood to
feel tacky. |
|
|
|
One TIME® starts protecting wood immediately upon application. |
|
|
|
One TIME® is cured by both direct and indirect sunlight. Under overcast
conditions, 48 hours is needed for curing. In direct sunlight, One TIME® cures
in less than 48 hours. DO NOT APPLY One TIME in an enclosure. Also, DO NOT
apply under very large roof covered areas. Porches with normal roofs are safe. |
|
|
|
For best results, One TIME® should be applied when temperatures range from 60
-100 degrees Fahrenheit. Avoid application if rain is forecasted within 48
hours of application. |
|
|
|
Only a single application of One TIME® is required to effectively protect the wood. |
|
|
|
While the initial per gallon cost of One TIME® is higher than conventional wood
treatments, it is actually less expensive in the long-term. One TIME® covers
two-to-three times more square footage per gallon than other treatments,
requiring less product to complete a project. In addition, One TIME® is applied
only once every seven years, versus every one-to-two years for conventional
treatments, resulting in the need for less product and less labor. |
|
|
|
NOTE: Two year old 400 square foot deck including ordinary railings/spindles.
Assuming reapplication every 2 years and does not include preparing deck for
each application. |
|
|
|
|
|
| One TIME® is available nationally by calling 866-One-TIME
(866-663-8463) or ordering online. Bond Distributing products are also
available at all Do It Best stores nationwide, ACE Hardware
and through select independent hardware and lumber stores throughout the United States. |
|
 |
|
 |
|
|